correct way to install toilet tank bolts

Level Toilet Bowl: Place a level on the top rim of the toilet bowl and check to be sure the bowl is level in all directions.

DO NOT OVER TIGHTEN the nuts, as this can cause the base of the toilet bowl to crack! Hand tighten the nuts on the bolts, then use a deep socket or wrench to tighten up the bolts evenly from each side.

Attach Flange Bolt Nuts: Place the washers that came with the closet bolts on the toilet bowl base.

Position the bowl so it’s perpendicular to the wall behind it. You may need to slightly twist or rock the bowl back and forth to flatten out the wax ring until the bowl contacts the floor.

Seat Toilet Bowl: Turn the toilet bowl over, position the bowl so it’s centered over the toilet flange, and press the toilet bowl down firmly.

Since caulking the bowl can be messy, I prefer not to seal it unless there’s a gap between the floor and bowl. You can also seal around it after the bowl is in place, or not caulk it at all.

Caulk Toilet Bowl Base: If desired apply a bead of caulking or sealant around the base of the toilet bowl to seal it to the floor.

Remove Toilet Drain Cover: Remove the drain cover used to keep sewer gases from coming out of the drain pipe.

Position Wax Ring: Place the new wax ring on the drain opening in the bottom of the bowl with the rubber gasket facing away from the toilet bowl.

Slide the old bolts out of the slots in the flange, and slip the heads of the new ones in so the bolts are parallel to the wall behind the toilet.

Install Toilet Flange Bolts: It’s a good idea to replace the toilet flange closet bolts, even if the old ones are still usable.Remove the bowl and turn it upside-down on the floor, using a towel or foam pad for padding. Test Fit Toilet Bowl: Position the new toilet bowl over the toilet flange to make sure it fits on the floor without rocking.Now comes the fun part-installing your new toilet! How to install a toilet bowl:

Correct way to install toilet tank bolts